Led Cover 40124948; Bottom Cover 40124970 - JUKI TL-2200QVP Service Manual & Parts List

2013.3.6 最終校正用

3. LeD cover 40124948

LeD cover
1
setscrew
2
Disassembly
R e m o ve se tscre w 2 i n
the lower end face of the
needle bar mounting base,
together with the thread
guide. Loosen setscrew 3
and turn it so that it is ori-
ented as illustrated in the
figure. Then, remove LED
cover 1 .

4. Bottom cover 40124970

3 Bottom cover
Disassembly
Remove four cross slot set-
screws 1 from the center sec-
tion of the bottom of the frame.
Remove four sems setscrews
2 from both sides of the bot-
tom of the frame. Then, remove
bottom cover 3 .
assembly
Place LED cover 1 on the
front side of the frame. Place
the thread guide on the lower
end face of the needle bar
bushing mounting base and
fix it with setscrew 2 .
Insert setscrew 3 from the
jaw side of the frame and
tighten it to fix LED cover 1 .
assembly
Place bottom cover 3 on the
bottom of the frame. Fix it by
tightening four cross slot set-
screws 1 on the center sec-
tion and four sems setscrews
2 on both side of the bottom
cover.
–
setscrew
3
Point
The thread guide sec-
tion has to be located
in the notch of the LED
cover.
To remove the LED cov-
er, turn it as illustrated
in the figure.
1 setscrew (×4)
2 setscrew (×4)
Point
Insert all setscrews
into the correspond-
ing holes and secure-
ly tighten them.
4
–
Tool to be used
Hexagonal wrench
key (3 mm)
Flatblade screwdriver
Tool to be used
Phillips screwdriver
Hexagonal wrench
key (5 mm)