Table of Contents
Advertisement
Programming the LINKS2150
Program the LINKS2150 through Installer's Programming
at a system keypad, or via DLS-1 v6.7 downloading
software.
For instructions on using DLS-1 v6.7, please refer to your
DLS-1 manual.
For instructions on keypad programming using Installer's
Programming sections, please refer to section 4 "How to
Program" in your control panel Installation Manual.
To enter Installer's programming:
1. Go to Installer's Programming by entering
[*][8][Installer's code].
2. For PC5015, PC5010, PC5008, PC1565, PC1565-2P
and PC585: Go to the LINKS2150 programming
section by entering [803].
For PC1580: Go to the LINKS2150 programming
section by entering [86].
Programming Data
Most sections contain groups of 2-digit entries. The
keypad will beep twice after each 2-digit group is entered.
When a section is entered, on LED keypads, zone lights 1
through 4 will indicate, in binary format, the value of the
first digit in the section. Refer to the Binary Data Display
chart below.
2 3 4 5 6 7 8 9 A B C D E F
0
1
Value
Zone 1
Zone 2
Zone 3
Zone 4
Zone Light ON
Zone Light OFF
If you wish to change the digit displayed, enter the new
digit. If you wish to keep that digit unchanged, skip over
the digit by pressing the [F] Key. Hexadecimal numbers
may also be entered in most sections. Refer to
Hexadecimal Data Programming for instructions.
When you are done programing the section, enter the 2-
digit number of the next section to be programmed.
HEX data entry
Refer to HEX Data Programming
Reviewing Programmed Data
• Enter the 2-digit number of the section to be reviewed.
• LCD keypads will display the current data in the
programming section.
• LED keypads will display the first digit of data in the
section using zone lights 1 to 4 to represent the value,
in binary format. To advance the display to the next
digit, press the [F] key.
• At the end of the section, the keypad will beep several
times and then return to the Program Mode so that
another section can be selected for review or
programming.
HEX Data Programming
Certain programming sections may require the entry of
data in HEX (hexadecimal, or base 16) format. HEX
numbering uses the numbers 0 through 9 and the letters A
through F.
The letters A through F are represented by the number
keys 1 through 6. To enter data in HEX format, first press
∗
the [
] key. Press a number key from [1] to [6] to enter a
HEX digit then press the [
"decimal" values.
To enter HEX numbers:
A ....... Enter [
B ....... Enter [
C ....... Enter [
D ....... Enter [
E ....... Enter [
F ....... Enter [
∗
] key again to return to
∗
∗
][1][
]
∗
∗
][2][
]
∗
∗
][3][
]
∗
∗
][4][
]
∗
∗
][5][
]
∗
∗
][6][
]
5
Advertisement
Table of Contents
