Two-Bay Sff Rear Drive Cage Option - HP ProLiant DL380 Gen9 Server User Manual

Connected to the onboard x4 SATA connector
o
Install the access panel (on page 26).
12.
Slide the server into the rack.
13.
Connect each power cord to the server.
14.
Connect each power cord to the power source.
15.
Power up the server (on page 24).
16.

Two-bay SFF rear drive cage option

For rear drive cage installation, the front bays must be fully populated using the 12 LFF or 24 SFF drives. High
performance fans must be installed in all fan bays.
To install the component:
Power down the server (on page 24).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 24).
o
Remove the server from the rack (on page 25).
o
Remove the access panel (on page 25).
4.
Hardware options installation 82