Whirlpool WED9290FC HybridCare Installation Instructions Manual page 22

2.
Move the door strike
®
Using a T25 screwdriver, remove the 2 screws securing the
door strike to the door frame of the dryer. Rotate the strike
180° and attach to the opposite side of dryer door frame
as shown.
3.
Remove inner door from outer door
Position the door with the inside of the door facing up.
Using a Phillips screwdriver, remove the 10 screws securing
the inner door to the outer door. Lift off the inner door and
set aside.
22
4.
Remove outer window assembly
from trim ring
Using a Phillips screwdriver, remove the 2 screws from the
outer window retainer and rotate the outer window assembly
clockwise until the square notches line up with the 4 tabs on
the trim ring indicated with arrows in figure A above. Then lift
out the outer window and retainer up and off the trim ring and
set aside (B).
Fig. A
Fig. B