Whirlpool WED9290FC HybridCare Installation Instructions Manual page 21

5.
Reinstall hinge and latch on
opposite sides
®
Using a T25 screwdriver, reinstall the latch plate and latch
backing plate with the 3 screws removed earlier and the hinge
assembly with the 5 screws on the opposite sides from which
they were removed.
6.
Reinstall inner door assembly
Position the door with the inside of the door facing up. Using
a Phillips screwdriver, reinstall the 10 screws securing the
inner door to the outer door.
7.
Using a T25
dryer. Insert the tabs on the hinge into the mounting slot
and slide down to engage the top tab. Secure in place
with the 4 screws removed earlier.
Reverse door swing flat glass – single handle
1.
Bottom
of door
IMPORTANT: If the protective film has not yet been removed
from the dryer, peel the film from the dryer door before
proceeding.
Using a T25
door hinge to the dryer and lift up and out to remove the door.
Place the door on a soft towel or other non-scratch surface.
Reinstall the 4 screws in the holes.
Reinstall door on dryer
®
screwdriver, remove the 4 screws on the
Remove door from dryer
®
screwdriver, remove the 4 screws securing the
21