Download  Print this page

Installation Requirements; Tools And Parts - Whirlpool WED9290FC HybridCare Installation Instructions Manual

Heat pump dryer
Hide thumbs

Advertisement

Installation Requirements

TOOLS AND PARTS

Gather the required tools and parts before starting installation.
Tools needed:
Flat-blade screwdriver
Wire stripper (direct wire
installations)
1/4" and 5/16" nut driver
(recommended)
Utility knife
Level
#2 Phillips screwdriver
Channel locks
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Tape measure
Pliers
Parts supplied:
Leveling legs (4)
Cable ties (2)
Parts package is located in dryer drum. Check that all parts
are included.
NOTE: Do not use leveling legs supplied with dryer if installing
with a pedestal or a stack kit.
If using a power supply cord:
Use a UL-listed power supply cord kit marked for use with
clothes dryers. The kit should contain:
A UL-listed 30-amp power supply cord, rated 120/240 volt
minimum. The cord should be type SRD or SRDT and be
at least 4 ft. (1.22 m) long. The wires that connect to
the dryer must end in ring terminals or spade terminals
with upturned ends.
A UL-listed strain relief.
Additional Accessories:
Refer to your Use and Care Guide for information about
accessories available for your dryer.
6' (1829 mm) drain
hose with couplers
(Not supplied with dryer)
3

Advertisement

loading

  Related Manuals for Whirlpool WED9290FC HybridCare