Fingerprint Reader Assembly - HP EliteBook 755 G3 Maintenance And Service Manual

Fingerprint reader assembly

Description
Fingerprint reader assembly (includes cable, bracket, and bezel)
Before removing the fingerprint reader assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the following components:
a. Keyboard (see
b. Hard drive
c. Internal base plate
Remove the fingerprint reader assembly:
1. Disconnect the fingerprint reader board cable from the system board (1).
2. Lift the mylar cover, and remove it from the computer (2).
3. Slide the bracket right, and then lift it off the top cover (3).
Bottom cover on page
Battery on page
Keyboard on page 50)
(Hard drive on page 40)
(Internal base plate on page
34).
39).
55)
Component replacement procedures
Spare part number
821165-001
61