Other Maintenance Functions; Changing The Time For Warning Of Wiper Replacement [Wiper Level] - MIMAKI JV5-130S Operation Manual

CHAPTER 4 Daily Maintenance

Other maintenance functions

Changing the time for warning of wiper replacement [WIPER LEVEL]

The wiper is consumable. The heads are easily soiled in a dusty environment.
The heads cannot be cleaned adequately with a curled or worn wiper. This printer gives the wiper replace-
ment warning earlier than standard depending on the operating environment.
10/10 Displays the wiper replacement warning when wiping has been performed the standard number of times.
(Initial value)
9/10 Displays the wiper replacement warning when wiping has been performed nine tenths of the standard
number of times.
8/10 Displays the wiper replacement warning when wiping has been performed eight tenths of the standard
number of times.
1/10 Displays the wiper replacement warning when wiping has been performed one tenth of the standard
number of times.
STEPS:
1
Make sure that the printer is in LOCAL mode, and then select [MAINTENANCE] using
the [FUNCTION] key and press the [ENTER] key.
If it is in REMOTE mode, press the [REMOTE] key.
2
Select [WIPER LEVEL] by pressing the [ ] key seven times and press the [ENTER]
key.
Downloaded From ManualsPrinter.com Manuals
Soiled wiper
Available setting values of time for warning of wiper replacement
PRE PRT AFT
35°C 40°C 50°C
L. ∗ >
[JV5-01]
width : ∗∗∗∗ mm
MAINTENANCE
ST.MAINTENANCE <ent>
Examples of defective wiper
FUNCTION
MAINTENANCE
7
times
MAINTENANCE
WIPER LEVEL

Other maintenance functions

Curled wiper
PRE PRT AFT
35°C 40°C 50°C
<ENT>
<ent>
4-39