Cleaning The Wiper And Ink Caps [Carriage Out] - MIMAKI JV5-130S Operation Manual

CHAPTER 4 Daily Maintenance

Cleaning the wiper and ink caps [CARRIAGE OUT]

The ink caps prevent the nozzles in the heads from drying and thus being clogged.
The wiper wipes off the ink adhering to nozzles.
As the printer is used, the wiper and ink caps gradually become stained with ink and dust.
If nozzle missing cannot be corrected even after executing the CLEANING function (Refer to "If the
printed pattern is abnormal (Cleaning) (p.3-30)" ) , use the supplied cleaning kit.
The cleaning kit contains the following items. Do not use alcohol or water.
You are recommend to perform cleaning frequently in order to maintain a high image quality and keep the
printer in good condition.
When cleaning the ink station or heads, be sure to wear the supplied goggle
and gloves. If you do not use the goggle, you may get ink in your eyes.
Do not move the carriage out of the capping station by hand.
Follow the following procedure to move the carriage.
STEPS:
1
Make sure that the printer is in LOCAL mode.
If it is in REMOTE mode, press the [REMOTE] key.
2
Press the [ST.MAINT] key and press the [ENTER] key.
When [CARRIAGE OUT] is displayed, press the [ENTER] key. Then the carriage moves to above the platen.
Downloaded From ManualsPrinter.com Manuals

Cleaning the wiper and ink caps [CARRIAGE OUT]

cleaning solution (SPC-0369)
Dropper
Cotton swab
Gloves
PRE PRT AFT
35°C 40°C 50°C
L. ∗ >
[JV5-01]
width : ∗∗∗∗ mm
ST.MAINTENANCE
CARRIAGE OUT <ent>
4-7