Replacing The Flippable White Background Strip(S) - Kodak i5000 Series User Manual

Replacing the flippable
white background strip(s)
A-61670 August 2014
In the rare case that you may need to replace the flippable white background
strip(s), follow the procedures below.
1. Turn off the scanner.
2. Open the scanner cover.
3. Using your fingers or the supplied screwdriver, loosen the two screws on
each end of the upper background strip and remove it from its position.
4. Disconnect the background strip connector.
5. Connect the new background strip connector with the cable. Be sure it is
securely in place.
6. Install the new background strip and tighten both screws on each side to
secure the background strip.
NOTE: Be sure to align the springs over the tabs in the scanner frame.
Verify that the background moves up and down freely.
7. Repeat Steps 2 - 5 to replace the lower background strip.
8. Close the scanner cover.
7-15