Table of Contents
Advertisement
E. Reverse clutch, paper exit roller
(1) Reverse clutch removal
1) Disconnect one connector.
2) Remove the resin E-ring.
3) Remove the reverse clutch.
3
1
■ Note for reassembly
Attach the stopper of the reverse clutch along with the rib on the
motor mounting plate.
(2) Paper exit roller removal
1) Remove the E-ring.
2) Slide the bearing.
3) Remove the paper exit roller.
4) Remove the E-ring.
5) Remove the bearing.
4
5
3
2
1
2
MR-2019/2018/MY-1034 DISASSEMBLY AND ASSEMBLY 5 - 2
F. Drive unit
(1) Transport unit removal
1) Disconnect four connectors.
2) Remove the harness from the clamp.
3) Remove the snap band.
4) Remove one screw.
5) Remove the earth wire.
6) Remove one screw.
7) Disconnect the RADF harness.
3
1
1
2
8) Remove four screws.
9) Remove the transport unit.
8
8
■ Note for reassembly
Before assembly, be sure to check that the harness is passed
through the rib.
Arrange the RADF harness to the outside of the base tray so that it
is nit pinched before assembly.
1
5
4
1
6
7
8
9
Advertisement
Table of Contents
