Jenn-Air JXD7036YS Installation Instructions And Use & Care Manual page 7

Cabinet Dimension
NOTES:
■ See cooktop manufacturer's instructions for cooktop cutout
depth and width.
■ Use dimensions for vent system cutout location that applies
to your installation.
Countertop Cutout Dimensions
IMPORTANT: Countertops with a bull-nosed front edge are not recommended for these installations.
Some models require a countertop deeper than 25" (63.5 cm); see the following "Countertop Cutout Dimensions Chart."
To avoid mistakes, it is recommended that the cooktop and vent cutouts be drawn on the countertop before making any cutouts.
See the Installation Instructions that came with your cooktop for complete cutout dimensions, location dimensions and installation
details.
A= ¹⁄₂" (12.7 mm)
minimum
21⁵⁄₁₆"
(54.1 cm)
Cutouts are
for 3¹⁄₄" x 10"
(8.3 x 25.4 cm)
rectangular or 6"
(15.2 cm) round
vent system.
Locate power
supply junction
box at lower
left hand
rear corner
of the cabinet.
B
A. Downdraft vent
B. Cooktop
C. Measurement of cooktop rear overhang
D. D = Measurement of cooktop rear overhang
¹³⁄₁₆
(C) + 1 " [46.2 mm] (E)
10" (25.4 cm)
(54.1 cm)
Centerline of cooktop cutout
■ Interior mounted blower systems connect with 3¹⁄₄" x 10"
(8.3 x 25.4 cm) rectangular or 6" (15.2 cm) round vent system.
The cutout locations for this vent system will depend on your
specific installation.
D
E
C
A
¹³⁄₁₆
E. 1 " (46.2 mm)
F. ½" (12.7 mm) minimum
G. ¼" (6.4 mm) minimum
H. Countertop and backsplash
I. ½" (12.7 mm) minimum
21⁵⁄₁₆"
F
G
H
I
7