Cleaning And Care; Cleaning The Dryer; Cleaning The Lint Filter; Cleaning The Exhaust Duct - Bosch Nexxt DLX Series Operating, Care And Installation Instructions Manual

Choose a time program
1. Rotate program selector to Time
dry/.... min.".
- Select the drying time from the
following table according to the
laundry type.
Laundry type Required drying time
Thin woolen pullover 80 min.
(approx. 0.8lbs/350 g) (e.g. 60 + 20 min)
Thick woolen pullover 90-120 min.
(approx. 1.9lbs/850 g) (e.g. 60 + 40 min)
Skirt 60-90 min.
Trousers 60-90 min.
Small items 30 min.
(e.g. gloves)
Shoes 30 min.
2. Press the Start/Stop" button.
The Start/Stop" indicator light
illuminates.
3. If the item of clothing still contains
residual moisture after the
indicated drying time:
q Fold the item of clothing so that
the damp parts are on the
outside.
q Restart the program and reduce
the drying duration depending
on the degree of residual
moisture.
4. After drying, spread out the
laundry at air for approx. 15 min.
(shoes for approx. 30 min.).
5. Remove the lint filter.
6. Take the dryer rack out of the
drum.
7. Re insert the lint filter.

Cleaning and care

Cleaning the dryer

d
WARNING
TO AVOID
RISK OF EXPLOSION!
Never use solvents or highly
flammable liquids for cleaning.
CAUTION
Incorrect cleaning may damage
the dryer. Do not spray with a
water jet. Do not use scouring
agents or all purpose cleaners.
Do not use steam cleaners.
Wipe the housing and fascia with a soft
cloth and soapy water only.
Wipe the drum, door seal and inside of
the door with a damp cloth only.

Cleaning the lint filter

A dirty filter extends the drying time and
increases energy consumption.
The filter should be cleaned before and
after each drying process.
If a warning signal and an E01 warning
message are emitted during a drying
program, clean the filter immediately
and check the exhaust duct.
i The program interrupts
automatically.
1. Switch off the dryer. Program
selector to Off".
d
CAUTION
The inside of the door heats up
during the drying process.
2. Open the door.
3. Remove the lint filter.
d
4. Remove lint by stroking your hand
over the filter.
The filter should be lightly scrubbed
twice a year with warm soapy water.
The filter is cleaned when it no longer
holds water. The filter must be dried
thoroughly before being replaced.
5. Insert the filter.
6. Close the door.

Cleaning the exhaust duct

Inspect and clean the exhaust ducting
at least once a year to prevent
clogging. A partially clogged exhaust
can lengthen the drying time.
q Turn off the circuit breaker
q Pull out power supply plug
q Close the shut off valve.
q Disconnect the duct from the
d
dryer.
q Vacuum and reconnect the duct.
d
WARNING
Remove gas connection before
moving the dryer to clean the duct.
Be careful not to destroy the gas
connection when cleaning the duct.
d
19