Program Selection; Automatic Programs; Special Programs; Time Programs - Bosch Nexxt DLX Series Operating, Care And Installation Instructions Manual

- To ensure a uniform drying result,
sort the laundry according to fabric
type and drying program.
- Fasten zippers, hooks and eyes.
Fasten loose belts, apron strings,
etc..
- Do not overdry easy care laundry
risk of wrinkling! Leave laundry to
dry in the air.
- Do not iron laundry immediately
after drying. Place the laundry in a
pile for a short while. Residual
moisture will then be distributed
uniformly.
- Knitted textiles (e.g. T shirts,
cotton jersey laundry) often shrink
when dried for the first time. Do
not use the "Very dry/Extra dry"
program.

Program selection

For optimum drying results your dryer
offers several program groups and
additional options.
Select the required drying program
from the program table according to
the examples (see page 16).

Automatic programs

There are automatic programs for
different types of textiles.
(Regular/Cotton or Permanent Press).
Regular/Cotton
Permanent Press
The program sequence of automatic
programs is controlled via sensors. The
duration of the program depends on
the measured degree of moisture in the
laundry and on the selected degree of
dryness (e.g. Damp dry or Extra dry).

Time programs

Time programs run for a specific time
(20, 40, 60 minutes).
In the "Air fluff/No heat" stage the dryer
runs on ambient air without a heat
supply for 20 minutes.

Options

Delicates
Press the "Delicates/low temp." button
for temperature sensitive textiles.
Observe the care information or
symbols on the textiles. The
temperature of the drying process is
reduced, the drying time is extended.
Signal
Your dryer outputs different signals, if
the "Signal" button is pressed.
Signal Type
Start Short tone
Damp dry Sequence of medium
length tones
End Sequence of short
tones
Mal operation Sequence of long tones
Warning of Sequence of long tones
malfunction
i The signal
Warning of malfunction" is active
in any case.
Indicator of program
sequence
The dryer uses an electronic scanning
system for all programs except the time
programs . A moisture sensor
continuously checks the moisture in the
laundry. Drying ends automatically as
soon as the selected degree of dryness
has been reached.
The drum continues to rotate at
specific intervals for one hour to
prevent creasing.
The current degree of drying and the
level reached during the program
sequence is indicated via indicator
lights (Drying, Damp dry, Regular dry,
Wrinkle block) .
i If the indicator light Wrinkle block"
illuminates when the program
selector is in Off-Position - turn off
the circuit breaker and call for
customer service!
15