Bottom exhaust kit
part no. WTZ1270
Note:
The maximum permitted number of 90°
elbows (including this side exhaust kit)
is four!
Left hinge kit
part no. WZ 1260
The door catch can be reversed if
necessary. The door is hinged on the
right at the factory.
Pedestal Mounting Kit
part no. WTZ 1295
If mounting the dryer on the pedestal
follow the instructions supplied with the
pedestal.
Mobile home kit
part no. WTZ 1275
Note:
Please check with the Authority Having
Jurisdiction in your area to verify if a gas
dryer can be installed in your mobile
home. Once that has been verified,
installation of the dryer shall conform to
the Manufactured Home Construction
and Safety Standard, Title 24 CFR, Part
3280 {formerly the Federal Standard for
Mobile Home Construction and Safety,
Title 24, HUD (Part 280)}, and/or
Standard CAN/CSA Z240 MH.
Please use mobile home kit number
WTZ 1275 for means to secure the
dryer to the structure.
See page 9 Exhaust Air Connection"
for the exhaust duct installation
instructions.
The exhaust duct must be securely
fastened to a noncombustible portion
of the mobile home structure and must
not terminate beneath the mobile
home.
An opening to the outside must be
provided during installation. Insure that
the free area of the opening for the
introduction of outside air is not less
than twice the area of the dryer exhaust
outlet or use at least a 5 inch diameter
2
exhaust or at least a 25 in
square
exhaust duct for the opening.