Cleaning The Moisture Sensor; Cleaning The Bearing Shield; Change The Light Bulb - Bosch Nexxt DLX Series Operating, Care And Installation Instructions Manual

Cleaning the moisture
sensor
The moisture sensor has to be cleaned
because a fine layer of transparent
buildup is deposited on the sensors.
This deposit can easily be removed by
wiping the sensors (the two bars next
to the lint filter) with a cloth and a little
white vinegar.
Use white vinegar only!
Clean the moisture sensor once a
month.
Cleaning the bearing
shield
Over time, fluff from the drying process
collects in the bearing shield.
This fluff can be easily removed using
your vacuum cleaner, at least once a
month.
20

Change the light bulb

The dryer light turns on inside the drum
when you open the door.
To change the light bulb:
q Set program selector to off".
q Turn off the circuit breaker.
q Pull out power supply plug.
q Open the door and locate the light
bulb on the upper left side of the
seal.
q Loosen the screw of the cover and
open the cover.
q Turn bulb counterclockwise.
Replace the bulb with a new
appliance bulb only (obtainable
through parts department).
q Replace the cover and secure with
the screw.
q Plug in dryer or reconnect power
supply.