NuTone NC300 series Operating Manual page 3

Note: For the first two seconds, the tuner scans at slow speed
to allow for fine tuning. After two seconds, the tuner scans at
fast speed.
preset radio stations
To preset radio stations:
1. Press POWER to turn on the music.
2. Select FM or AM. See Music Settings/Music Source for
instructions.
3. Use TUNE UP or TUNE DOWN to find a station. See Tune
the Radio section for seek and scan functions.
4. Simultaneously press TUNE UP and TUNE DOWN to enter
Store Preset mode. The display shows PRESET and a
preset number.
5. If you don't want to assign a preset number, wait 5 seconds
and your selected radio station will automatically be assigned
to the preset number that is displayed. If you want to select
the preset number, press the PRESET button repeatedly to
cycle through numbers1-8 until you reach the preset number
you want.
6. Wait 5 seconds. The display updates to show the new station
for the selected preset number.
Note: This activity can be cancelled at any time during
the process by pressing TUNE UP and TUNE DOWN
simultaneously again, and no new preset is stored.
scan mode
Two scan modes are available. The scan mode for the room
stations is set at the master. The two scan modes are identified
in the next figure. To set your scan mode:
• Scan 1—Allows the Indoor/Outdoor Remote stations to scan
through the four music sources (AUX, AM, FM, CD). On
radio bands AM and FM, Scan 1 scans through the preset
radio stations: AM 1-8 and FM 1-8. See Music Settings/Radio
Settings for information on how to preset radio stations.
• Scan 2—Allows Indoor/Outdoor remote stations to scan
through the four music sources (AUX, AM, FM, CD.) On
radio bands AM and FM, Scan 2 scans all strong stations
before moving on to the next source.
models nm
To set the Scan Mode:
To change the scan mode, simultaneously press and release
PRESET and SOURCE again. The display shows either Scan1
or Scan2.
Note: Exit out of scan mode by pressing PRESET and SOURCE
or waiting for the display to show the clock time again.
audio settings
volume
• Music—Adjusts the volume for system music.
• Master Station—Adjusts the volume for the speaker on the
Master Station only.
• Intercom—Adjusts the volume for the system intercom.
100 300
• nc
Page