Hilti TE 700-AVR Operating Instructions Manual page 20

To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
Modification of the power tool or tampering with its parts is not permissible.
2.2 Chuck
TE‑Y chuck
2.3 Switch
On / off switch
Power level selector switch (100%, 70%)
2.4 Grips (with soft synthetic foam rubber covering)
Vibration-absorbing grip
Vibration-absorbing, rotatable and pivotable side grip
2.5 Lubrication
Gearing and hammering mechanism with separate lubrication chambers
2.6 Active vibration reduction
The power tool is equipped with an AVR active vibration reduction system which reduces vibration significantly
compared to power tools without active vibration reduction.
2.7 TPS theft protection system (optional)
The power tool may be equipped with the TPS Theft Protection System as an option. If the power tool is equipped
with this optional feature it can be unlocked and made ready for operation only through use of the corresponding TPS
key (see section "Operation / TPS theft protection system (optional)").
2.8 Protective features
Temperature and vibration protection provided by separating the plastic housing case and grips from the internal
machine.
Electronic restart interlock to prevent the power tool starting unintentionally after an interruption in the electric supply
(see section "Troubleshooting").
Electronics with self-acting protective system against overvoltage and overheating.
2.9 LED indicators
Service indicator LED (see section "Care and maintenance / service indicator")
Theft protection system indicator (optional) (see section "Operation / TPS theft protection system (optional)")
Power level indicator (see section "Operation / setting chiseling power")
2.10 Items supplied as standard
1 Power tool
1 Side handle
1 Grease
1 Cleaning cloth
1 Operating instructions
1 Hilti toolbox
2.11 Using extension cords
Use only extension cords of a type approved for the application and with conductors of adequate cross section.
The power tool may otherwise lose performance and the extension cord may overheat. Check the extension cord for
damage at regular intervals. Replace damaged extension cords.
en
17