Assembly - GreenWorks 2600007 Instruction Manual

E. Led light
F. Handle pivot closure
G. Central handle
H. Ignition key
I. Exhaust chute
J.
K. Auger
L. Auger compartment
M. Wheel
N. Lower blade
O. Transport handle
P. Battery compartment
Q. Battery charger (supplied separately)
R. Battery (supplied separately)

4. ASSEMBLY

For storage and transport purposes, some
components of the machine are not installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
4.1 ASSEMBLY COMPONENTS
The packaging holds the components needed
for assembly 4 ) listed in the following table:
Component
Snow thrower
Discharge chute
adjustment handle
Handle
Handle
Spacers and screws for
securing the handle in place
Spacers and screws for
securing the handle in place
Ignition key
Instructions
4.2 UNPACKING
1. Cautiously open the packaging, paying
attention not to lose components.
2. Consult the documentation in the box,
including these instructions.
3. Remove all the unassembled parts from the
box.
4. Lift the snow thrower from the box.
5. Dispose of the box and packaging in
compliance with local regulations.
1. Assemble the central part of the handle
2. Position the upper handle
3. Fasten the electrical cable in place with the
1. Assemble the handle
2. Insert the spring pin in the hole and fasten.
3. Pass the handle obtained in the
4. Insert the end of the handle in the
5. Check the discharge chute by turning it
1. Insert the
Fig. N.
4 1
2. Fit the tabs on both sides in the rotation
4.A, 4.A1, 1
4.A2
3. Push until the pins
4.B 1
4.C 1
4.D, 4.E 2
4.F, 4.G 4
4.H 1
4.I 1
Used to start and stop the motor. The
- 1
ignition key has two positions
1. Key removed - OFF - the motor stops and
2. Key inserted - ON - the motor can start and
Used to start and stop the motor.
EN - 7
4.3 HANDLE ASSEMBLY
4.C) on the snow thrower (lower part of
handle), fastening it with screws
on both sides.
central one and fasten it with the
screws and fastenings
cable gland
4.4 DISCHARGE CHUTE ADJUSTMENT
HANDLE ASSEMBLY
extension shaft
in place with a spring pin
the holes on the shaft and the joint are aligned.
handle support
coupling hole on the chute, keeping it straight
and with the grip upwards
entirely in both directions. The chute must
freely rotate 9 ).
4.5 DEFLECTOR ASSEMBLY
the upright position
eyelets 6.B).
with a click.
5. CONTROLS
5.1 IGNITION KEY
cannot be restarted.
run.
5.2 STARTER LEVER
4.D, 4.E)
4.B) on the
4.G, 4.F).
4.I).
5.A1) using the
5.A), fastening it
5.A2). Ensure
lower
5.B).
5.C).
on the discharge duct in
6.A).
into the holes
8.H):