Lenovo x3650 M5 Installation And Service Manual page 1062

Explanation: An error occurred while saving UEFI settings to the IMM. Error Updating System
Configuration to IMM
Severity
Warning
User Response
Complete the following steps:
1. Use the Setup Utility to verify and save the settings (which will recover the settings).
2. Reset the IMM from the CMM.
3. Use CMM to remove auxilliary power from the compute node. This will reboot the compute node.
4. Check the IBM support site for an applicable service bulletin or firmware update that applies to
this error.
5. Update the IMM Firmware.
6. Use CMOS clear jumper to clear CMOS
7. (Trained service technician only) Replace the system board.
• W.3808003 [W.3808003]
Explanation: Unable to retrieve the system configuration from the IMM. Error Retrieving System
Configuration from IMM
Severity
Warning
User Response
Complete the following steps:
1. Use the Setup Utility to verify and save the settings (which will recover the settings).
2. Reset the IMM from the CMM.
3. Use CMM to remove auxilliary power from the compute node. This will reboot the compute node.
4. Check the IBM support site for an applicable service bulletin or firmware update that applies to
this error.
5. Update the IMM Firmware.
6. Use CMOS clear jumper to clear CMOS
7. (Trained service technician only) Replace the system board.
• W.3818005 [W.3818005]
Explanation: The CRTM flash driver could not successfully flash the staging area. The update was
aborted CRTM Update Aborted
Severity
Warning
User Response
Complete the following steps:
1. Continue booting the system. If system does not reset, manually reset the system.
2. If the error is not reported on the subsequent boot, no additional recovery action is required.
1050
Lenovo System x3650 M5 Installation and Service Guide