Kärcher BR 40/25 C Bp Manual page 24

Note:
The appliance is switched off automatically
if the battery has been fully discharged
(battery indicator is red). You can restart
the device only after you have fully charged
the battery.
Spare batteries
You can acquire additional sets of batteries
to avoid the waiting time when the batteries
are getting charged. You can then replace
the empty battery set in the appliance by a
charged set of batteries.
Note:
The spare battery set must show a mini-
mum voltage of 25.8 V when you connect it
to the device. If the voltage is lower, the
deep discharge protection in the electron-
ics prevents a start-up of the device. In this
case, the battery set must be charged com-
pletely.
Setting the Vacuum Bar
Oblique position
To improve the vacuuming result on tiled
floors the vacuum bar can be turned to an
oblique position of up to 5°.
 Release the wing nuts.
 Turn the vacuum bar.
 Turn the vacuum bar.
Inclination
If the vacuum result is unsatisfactory the in-
clination of the straight vacuum bar can be
modified.
 Release the wing nuts.
 Tilt the vacuum bar.
24
 Tighten the wing nuts.
Setting the Advance Speed (Only
 Turn the running gear to the front with
your foot.
 Reducing the speed: Turn the button in
"–" direction.
 Increasing the speed: Turn the button in
"+" direction.
 Turn the running gear to the back with
your foot.
 Turn the program selection switch to
the desired cleaning program.
 Set the water quantity according to the
degree of dirt accumulation and the
floor covering.
 Lower the vacuum bar.
 Turn on the brushes by pulling the con-
trol handle.
ATTENTION
Risk of damage to the floor covering. Do
not operate the appliance on the spot.
– 8
EN
BD Model)
Cleaning