IDEAL 4810-95 Operating Instructions Manual page 17

http://www.monomachines.com
Operation
• •
C
D
E
B
http://www.monomachines.com
B
A
A
C
IDEAL 4810-95, IDEAL 4850-95
The measurement is set with the backgauge
crank.(A) The symbol – rotary direction –
moves to the right on the display (B) (see
picture C). The rotary direction of the
backgauge crank (A) is indicated on the right.
Keep turning the backgauge crank to the right
until a measurement appears (see picture E).
The reference position is reached.
The cutting size can now be set with the
handle (A).
If the backgauge is right at the front the
symbol – rotary direction –
left (see picture D). Turn the backgauge crank
to the left until the rotary direction appears on
the right in the display (see picture C).
Afterwards turn the backgauge crank to the
right until a measurements appears (see
picture E). The reference position is reached.
The cutting size can now be set with the
handle (A).
Measurement is shown on the display in
inches or cm (B).
IDEAL 4810-95
If display (C) shows "
completely opened.
Turn the hand-wheel for clamping (A)
completely to the left until the backgauge (B)
is activated.
For More Info
Click Here --->
- 17 ­
will move to the
AB
" the clamp must be