Eventide harmonizer H8000 Programming Manual page 90

®
The Harmonizer Programmer's Manual
8 char name
The is used only if this module's userobject is
connected directly to the head module. Normally its
userobject will be connected a menupage module. Refer to
the Modules Section for complete information.
Percentknob Module
The percentknob module is very similar to the knob
module. The only difference is that the control output value is
divided by 100. Refer to the Modules Section for complete
information.
Tapknob Module
The tapknob module is a modification of the standard knob
module. Just like the knob module, the menu statement
is
used to create the 20-character text display. However, instead
format is used. The tapknob
%f %s
of using the format, the
%s
module creates an 8-character numeric result that is inserted in place of the .
The tapknob module creates a tapered (non-linear) control
steps
that has a "selectable" number of (instead of the usual
resolution taper
parameter) and a "selectable" waveform.
taper
The greater the specifier, the more non-linear the
parameter response. Refer to the Modules Section for
complete information.
Rfader Module
The rfader module creates a graphic on the
PARAMETER
screen. The graphic, including title, takes up four lines of the
screen and one quarter of the width of the screen. Up to four of
these modules can fit on one menu page.
Nine characters of the menu statement are displayed above the
graphic as a title. Refer to the Modules Section for complete
information.
© 1999-2008 Eventide, Inc.
Page 88 of 97 Release 1.3