Configure The Settings Relating To Images And Audio [Image/Audio]; Configure The Settings Relating To The Image Capture Mode [Jpeg/H.264] - Panasonic WV-SW550 Series Operating Instructions Manual

11 Configure the settings relating to images and
audio [Image/Audio]
The settings relating to JPEG and H.264 images such as the settings of image quality, audio, etc. can be
configured on this page.
The "Image/Audio" page has 3 tabs; the [JPEG/H.264] tab, the [Image quality] tab and the [Audio] tab.
11.1 Configure the settings relating to the image
capture mode [JPEG/H.264]
Click the [JPEG/H.264] tab on the "Image/Audio" page. (®page 40, page 42)
[Image capture mode]
Select an image capture mode from the following.
2 mega pixel [16:9]/1.3 mega pixel [16:9]/1.3 mega pixel [4:3]/3 mega pixel [4:3]
•
Default: 2 mega pixel [16:9]
IMPORTANT
The positions of areas may move out of alignment when the "Image capture mode" setting is changed
when the following area settings are configured. Therefore we recommend that you configure each area
setting after configuring the "Image capture mode".
–
mask area (®page 91)
–
privacy zone (®page 98)
–
VMD area (®page 114)
–
VIQS area (®page 99)
–
Cropping outlines (®page 13)
Note
•
The other i-PRO series products do not support the aspect ratio of "16:9" unless otherwise stated. (As
of December, 2011)
•
When "On" is selected for "VIQS" and the setting value for the aspect ratio is changed from "4:3" to
"16:9", make sure that the VIQS setting value does not exceed the maximum designated range.
•
When "3 mega pixel [4:3]" is selected, the following functions become unavailable.
–
"Image quality" for JPEG (the quality becomes "Quality1")
–
H.264(2)
–
"Alarm image attachment" for mail notification
–
"Alarm image FTP transmission" for alarm
–
"FTP periodic image transmission" for periodic FTP transmission
–
"Cropping"
–
"Priority stream"

11 Configure the settings relating to images and audio [Image/Audio]

Operating Instructions 73