Configure The Settings Relating To The Alarm Image [Alarm] - Panasonic WV-SW550 Series Operating Instructions Manual

•
AUX output: AUX output will be supplied. The [AUX] buttons will be displayed on the "Live" page.
•
Default: Off
Note
•
AUX is a camera terminal that allows users to operate (Open/Close) arbitrarily from the "Live" page.
For example, an operator can remotely control lights in a place where the camera is installed by
connecting the terminal to the light controller.
•
Refer to the installation guide for further information about input/output rating of each terminal.
•
While "Alarm input" is being selected, an alarm is detected when the terminal status is changed to
"On". (Default)
It is possible to configure the setting so that an alarm is detected when the terminal status is changed
to "Off". Refer to the [Readme] file on the provided CD-ROM for further information about the setting.
[VMD alarm]
When clicking "VMD >>", the [VMD area] tab of the "Alarm" page will be displayed. (®page 116)
[Command alarm]
Select "On" or "Off" to determine whether or not to receive the command alarm.
The command alarm is the function that provides notification of a Panasonic protocol alarm from the other
cameras. When "On" is selected, alarm actions will be performed between multiple cameras.
•
Default: Off
[Originating port number]
Select a port number to be used to receive the command alarm.
•
Available range: 1-65535
•
Default: 8181
The following port numbers are unavailable since they are already in use.
20, 21, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 443, 554, 995, 10669, 10670, 59000-61000
13.2 Configure the settings relating to the alarm
image [Alarm]
Click the [Alarm] tab on the "Alarm" page. (®page 40, page 42)
The settings relating to the alarm image to be transmitted to an FTP server can be configured in this section.
The alarm image will be transmitted to an FTP server. To transmit alarm images to an FTP server, it is
necessary to configure the settings in advance. (®page 131)
IMPORTANT
•
Depending on the network line speed or the network traffic, images may not be transmitted at the exact
designated interval or period.
•
When "Alarm input" or "Manual" is selected for "Save trigger" on the [SD memory card] tab, images will
not be transmitted to the FTP server even when an alarm is detected. Set "Save trigger" to "FTP
error". (®page 50)
13 Configure the alarm settings [Alarm]
Operating Instructions 109