Table of Contents
Advertisement
K-M
H
IX
ARDWARE
4.3.5 – MIDI I
It is possible to control K-Mix's Mix bank parameters via a connected MIDI Expander. Any MIDI sent from
an external MIDI device into the Expander's MIDI IN jack will be used to control K-Mix. It is not possible,
however, to control the MIDI bank parameters from the MIDI Expander.
The Expander Control setting must be enabled from the K-Mix Editor in order to
control K-Mix from the MIDI Expander.
4.3.5.1 – C
HANGING
Program change messages sent to the MIDI Expander's MIDI IN jack can be used to change the
currently loaded preset.
• Program change 1–12 will load presets 1–12 (A–L), respectively.
• Program change messages must be sent on MIDI channel 16; program changes on any other
channel will be ignored by K-Mix.
4.3.5.2 – C
ONTROLLING
There is full control of the Mix bank parameters via input to the MIDI Expander. The specific messages
used to control the Mix bank are exactly the same as the messages used when controlling K-Mix from a
computer; these messages are detailed in section 4.3.3 – External MIDI Control Of Mix Bank.
4.3.5.3 – C
ONTROLLING
Control of K-Mix's MIDI banks via the MIDI Expander is not supported. You may only control K-Mix's Mix
bank parameters from messages sent to the MIDI Expander's MIDI IN jack.
MIDI E
NPUT VIA
P
RESETS
T
M
HE
IX
T
MIDI B
HE
XPANDER
B
ANK
ANKS
81
Advertisement
Table of Contents
