Keith McMillen Instruments K-MIX User Manual page 110

K-M E
IX DITOR
S P
TEREO AIRS
K-Mix channels 1 and 2, 3 and 4, 5 and 6, and/or 7 and 8 can be paired
into stereo channels. Once paired, their parameters sync up and follow
each other if any of them are adjusted.
E U
XAMPLE SE
1. Bring up channel 1's channel strip by clicking its channel select
button (in the editor).
2. Click the "Stereo Pairs" button; the button will turn white and the text will change to "Paired".
The parameters for channel 1 will copy into channel 2.
3. Adjust the fader level of channel 1 or channel 2, either by
clicking and dragging the fader in the editor, or by adjusting
the fader level on the K-Mix hardware.
4. Channels 1 and 2 will now move together and follow any
subsequent changes to settings in either channel.
E S
QUALIZER ECTION
The Equalizer section of the channel strip is home to the EQ parameters. Each of the 8 input
channels (and the main output bus) have their own 3-band, semi-parametric EQ available.
B B
YPASS UTTON
The bypass button enables or disables the EQ on the currently selected
channel.
• Clicking the button will toggle the state of the bypass.
• The button will light up
• The button will go dark when disabled (EQ bypassed).
L
OW
The EQ's lower band is a sweepable, dual-pole, low-shelving filter.
F K
REQUENCY
The low frequency knob controls the center frequency of the low-
shelf filter.
• Turn clockwise to increase the frequency; turn counterclockwise
to decrease the frequency.
• A specific value may be entered into the accompanying number box as an alternative
way of setting the frequency.
• Range: 20Hz – 400Hz
blue when enabled (EQ on).
& N B
NOB UMBER OX
Stereo Pairs
Ch.1&2 OFF
Stereo Pairs
Ch.1&2 PAIRED
EQUALIZER
HI
0.00 dB 3.24 kHz
Level Freq
MID
Level
Q
Freq
1.00 0.00 dB 346 Hz
LOW
0.00 dB 276 Hz
Level Freq
99