Table of Contents
Advertisement
F.A.Q.
D
I
O
NEED A COMPUTER TO USE
No, K-Mix can function as a completely standalone mixer. All EQs, compressors, noise gates, reverb, etc. live on
the board. Just power up K-Mix via a USB power supply and you're good to go!
Please note that while most parameters can be accessed directly from the K-Mix hardware, there are some
parameters that can only be accessed via the K-Mix Editor software, which does require connection to a
computer to function. Though, once you have edited these parameters via the editor they can be saved on the
K-Mix itself, enabling you to use your changes standalone, away from the computer.
Editor-only parameters are as follows:
•
Rumble Filter On/Off
•
Rumble Filter Frequency
•
Surround Speaker Layout selection
•
Bass Management On/Off
•
Bass Management Crossover Frequency
•
Surround Panner assignments
•
USB Pre/Post settings
•
MIDI CC/Note assignments
•
Input Channels 3–8 Line/Phono Switches
•
Pass Thru On/Offs
•
Expander Control
•
Phones Output Gain
•
Editor + Mixer View Linking On/Off
W
K-M
ILL
IX REMEMBER MY PREVIOUS SETTINGS THE NEXT TIME
?
ON
Yes, it is possible for K-Mix to remember your previous settings the next time it is turned on, even if you did not
save any of the changes made.
•
In order for K-Mix to power up in the exact same state as it was powered down, you
down your K-Mix by pressing and holding the [ ] button for three seconds. When powered down this way
K-Mix stores its current settings internally and automatically recalls them the next time it is powered on.
• Simply disconnecting K-Mix from its power source will not store the current settings for later; any unsaved
changes will be forgotten when K-Mix is next powered on.
W
K-M
ILL
IX WORK WITH COMPUTERS RUNNING
No, we do not currently support K-Mix for computers running Windows operating systems. K-Mix will not
function when connected to a computer running a Windows operating system.
K-M
?
IX
W
I
TURN IT
must manually power
?
INDOWS
141
Advertisement
Table of Contents
