Troubleshooting - Pioneer PDR-509 Operating Instructions Manual

Additional Information Additional Information

Troubleshooting

Below is a list of messages mainly related to playback and recording problems, together with a brief explanation and a page reference where you can find
more information:
Display
CHECK DISC
CHECK
(blinking display)
Display messages relating to recording:
Display
CAN NOT COPY The input signal is digital-copy protected with
SCMS
CAN NOT REC The digital source was interrupted.
The source is not audio, or is an incompatible
format (e.g. a
CHECK INPUT The source player was already playing when the
CD ?
DIGITAL SYNCHRO DIGITAL DIGITAL DIGITAL DIGITAL
SET UP
The unit is preparing to record.
REPAIR The recorder was switched off/unplugged after
recording without ejecting the disc. The
recorder could not write essential recording
information onto the disc.
REC FULL
No more recording is possible because the
available recording time of the disc has been
used up, or 99 tracks have already been
recorded on the disc.
Pro DISC
The loaded disc is a
professional use without the
U S E U S E U S E
U S E U S E
Display messages relating to playback:
Display Cause
NEW DISC A blank disc is loaded.
NO DISC An attempt is made to start playback without
loading a disc.
The unit is resuming an operation. If the power
RESUME
supply is cut off (either by mistake or due to a
power failure) during recording, the unit enters
resume mode once power is restored so that
additional recording is possible.
58
En
Cause
The disc is damaged or dirty.
The disc is loaded upside down.
A system error occurred, perhaps due to noise
or static electricity.
Cause
.
– ).
CD ROM
button was pressed.
SYNCHRO SYNCHRO SYNCHRO SYNCHRO
– or – disc for
CD R CD RW
CONSUMER CONSUMER CONSUMER CONSUMER CONSUMER
disignation.
Remedy
Take out the disc and check for dust, dirt, scratches, etc. Clean
as necessary.
Take out the disc and reload it label-side up.
If the same messages are displayed again after the disc is
reloaded, unplug the power cord and plug it in again. If the
same messages are still displayed, please contact a Pioneer
authorized service center.
Unplug the power cord and plug it in again. If the same
messages are displayed again, please contact a Pioneer
authorized service center.
Remedy
Record the source through the analog inputs.
Check that the digital input cable is connected properly and
that the power of the source player is on.
Check that the source is a regular music source.
Stop the source player. After a short time, 1 -
is displayed, and the recorder goes into synchro–record-pause
mode.
Wait until the message disappears.
While is displayed, the recorder automatically
REPAIR REPAIR
REPAIR REPAIR REPAIR
examines the recorded area of the disc and updates the track
numbers and recording time data. This process takes about 40
minutes for a fully recorded disc. Finalization or further
recording is possible once the
REPAIR REPAIR REPAIR REPAIR REPAIR
Use another disc, or erase the –
CD RW
Load a – or – disc that is designated as being for
CD R CD RW
consumer use.
Remedy
Only recording is possible on blank
Playback is not possible.
Open the tray and check that a disc is loaded.
Wait until the message disappears.
Reference
p.11
p.22
Reference
p.40
p.12
1 - 1 - - - - - -
1 - 1 - or
SYNC SYNC A L A L SYNC SYNC
SYNC SYNC SYNC A L A L A L SYNC SYNC SYNC
pp.31–34
message disappears.
disc.
pp.54-56
Reference
– or – discs. p.22
CD R CD RW
p.22