Adjustments And Indicators (180 And 250) - Kemppi MinarcTig 180 Operating Manual

2.6

adjustments and indicators (180 and 250)

3.
EN
4.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
switching the machine on
When you power on the machine, the green standby indicator and the main
switch are lit.
If the machine overheats or the supply voltage is too high or too low, the
welding operation automatically switches off, and the yellow overheating
indicator is illuminated. The light switches off again, when the machine
is ready for operation. Make sure that there is enough space around the
machine to allow the air to freely circulate and flow into and out off the
machine.
12 12
MinarcTig 180, 180MLP, 250, 250 MLP
1.
2.
5.
Standby indicator.
Pre/Post gas, upslope/downslope and main current parameter
indicator.
Welding parameter selector arrow keys.
Welding process selection button (MMA or TIG).
2T or 4T TIG torch switch selection button. Select 2T for short welds or
4T for long welds.
Ignition method selection button.
Current adjustment selector: panel control, TIG Torch remote or foot
pedal remote.
Welding current and parameter value control knob.
Welding current and parameter value display: time and amperes.
Overheating indicator.
10.
9.
6. 7.
8.