Table of Contents
Advertisement
Settings
The Ilumipod 7 IP Optic RGBW uses the Ilumicode unit for configuration
purposes.
Ilumicode
The diagram below shows how to connect the Ilumicode to this product.
Connections
Note that this connection will control multiple fixtures at the same time, all
having the same DMX address. To assign individual DMX addresses to
each fixture, you must connect the Ilumicode unit to each fixture,
individually. This means that you will also have to disconnect the DMX
output of the fixture under configuration if there are other fixtures connected
to it.
Ilumicode
Connection
Diagram
ILUMINARC® suggests you to connect no more than 20 fixtures in this
mode, while keeping the total distance to less than 60 m (197 ft). Otherwise,
you might need to use an optically isolated signal amplifier.
·
The RDM2go, which includes a built in ilumicode addresser along
with many other useful features is now available.
·
The Ilumicoode addresser is required for product configuration
(sold separately).
Ilumipod 7 IP Optic RGBW QRG
5
Advertisement
Table of Contents
