Microhard Systems IPN4G Operating Manual page 165

5.0 AT Command Line Interface
Description
Set UDP Point-to-Multipoint as point parameters
when IP Protocol Mode is set to UDP Point-to-
Multipoint (P)
Example
Input:
AT+MCTUPMP0=224.1.1.2,20002,20012,1<enter>
Response:
OK
Description
Set UDP Point-to-Multipoint as MP parameters when
IP Protocol Mode is set to UDP Point-to-Multipoint
(MP)
Example
Input:
AT+MCTUPMM0=0.0.0.0,20012,224.1.1.2,20002<enter>
Response:
OK
Description
Set UDP Multipoint-to-Multipoint parameters when
IP Protocol is set to UDP Multipoint-to-Multipoint
mode.
Example
Input:
AT+MCTUMPMP0=224.1.1.2,20012,1,224.1.1.2,20012<enter>
Response:
OK
© Microhard Systems Inc.
Command Syntax
AT+MCTUPMP0=<Multicast IP>, <Multicast
Port>, <Listener Port>, <Time to live>
AT+MCTUPMM0
Command Syntax
AT+MCTUPMM0=<Remote IP>, <Remote Port>,
<Multicast IP>, <Multicast Port>
AT+MCTUMPMP0
Command Syntax
AT+MCTUMPMP0=<Multicast IP>, <Multicast
Port>, <Time to live>, <Listen Multicast IP>,
<Listen Multicast Port>
AT+MCTUPMP0
165