Installing A Module - Nortel Ethernet Routing Switch 8010 Installation Manual

Installing a Module

For details about the operation of modules, refer to the documentation that was shipped with each
module.
Required tool: Phillips screwdriver
Remove a filler panel from a module slot.
1.
Align the module circuit board with the card
3.
guides in the chassis. Slide the module into a
slot in the chassis until the module touches
the backplane connectors.
9058FA
Make sure the inserter/extractor levers are
2.
rotated away from the front of the module.
9060FA
Rotate the inserter/extractor levers to seat the
4.
backplane connectors.
9059FA
9070FA
9