Caution; Description; Technical Data; Placing Into Operation - Weller WSP 80 Instructions Manual

English
Always place the soldering tool in the
safety rest while not in use.
Thank you for placing your trust in our company by purcha-
sing the Weller mirco-solderer WSP 80. Production was
based on stringent quality requirements which guarantee the
perfect operation of the device.

1. Caution!

Please read these Operating Instructions and the attached
Safety Information carefully prior to initial operation. Failure
to observe the safety regulations results in a risk to life and
limb.
The manufacturer shall not be liable for damage resulting
from misuse of the machine or unauthorised alterations.
Safety Informations
 Always place the soldering iron in the original holder.
 Remove all inflammable objects from the proximity of the
hot soldering tool.
 Use suitable protective clothing. Risk of burns from liquid
solder.
 Never leave the hot soldering iron unsupervised.
 Never work on voltage-carrying parts.

2. Description

The Weller micro-solderer WSP 80 features precise and quick
heating to the required solder temperature. An excellent
dynamic behaviour is achieved using an especially powerful
80W heater element. Together with the slimline form and the
simple change of soldering bits, this soldering iron can be
universally used in all situations from extremely delicate sol-
dering to those where there is a greater temperature require-
ment.
With an integrated grounding connector, there is the possibi-
lity for a grounding of the solder bit if required. The anti-sta-
tic handle and cables mean that the soldering iron satisfies
all requirements of the ESD safety.

Technical Data

Supply Voltage:
Power Rating:
Warm Up Time:
Max. Temp.:
Usable With:
3. Installation
Place the soldering iron in the safety holder. Remove all flam-
mable articles from around the soldering iron. Plug and lock
the connector (7) into the supply unit. Set the required tem-
perature on the supply unit. Wet the soldering bit with solder
once it has heated up.
5
24 V
80 W
approx. 10 sec. (50ºC - 350ºC)
450ºC
all 80 W power units
4. Grounding
If required, an grounding of the soldering bit can be created
via the supply unit. The connection possibilities for grounding
are described in the instructions for the supply unit.
5. Information for Operation
Changing soldering bits
- Hold the soldering iron with the bit slightly downwards.
- Loosen the knurled nut around the bit-sleeve (2).
- Pull the bit-sleeve (2) towards the front.
- The soldering bit now sits loosely in the sleeve.
Warning: Soldering bit is HOT!
Do not place or leave the hot soldering tip / calibration tip on
the cleaning sponge or on plastic surfaces.
When using a number of different solder bits, it is recommen-
ded that the soldering bit and sleeve are used together as a
quick change system. (see page 29)
Keep the heating element and solderin tip heat transfer sur-
faces clean.
Anti-static plastics containing conducting fillers are used to
prevent static charge build-up. This also means that the insu-
lating properties of the plastic are reduced.
The instructions for the use of the supply unit are valid in
addition to these here.
In the case of soldering work with very low heat requirement,
the reliability of the Setback function may be impaired.

6. Accessories

Soldering bits figure LT-Tips see pages 25 - 28.
Figure: Exploded Diagram, see page 30.
Subject to technical change without notice!
See the updated
www.weller-tools.com.
operating instructions at