Pto Clutch Lever - Kubota B2650 Operator's Manual

BPTO Clutch Lever
1. The PTO clutch lever engages or disengages the PTO
clutch which gives the PTO independent control.
2. Shift the lever to "ON" to engage the PTO clutch. Shift
the lever to "OFF" to disengage the PTO clutch.

(1) PTO clutch lever

A To avoid shock loads to the PTO, reduce engine
throttle from high idle to low idle by pushing up on
engine throttle when engaging the PTO, then open the
throttle to the recommended engine rpm.
A To avoid damage to PTO clutch and implement, shift
the PTO clutch lever slowly, when engaging the PTO
clutch. Do not keep the PTO clutch lever half way.
A To avoid damage of transmission, when PTO select
lever is not smoothly shifted, slightly shift PTO clutch
lever.
A To avoid damage of transmission, do not shift PTO
select lever until the PTO has stopped completely.
A Tractor engine will not start if the PTO clutch lever is in
the engaged "ON" position.
A When you stand up from the seat with the PTO clutch
lever in the "ON" position, the engine will stop
regardless of the position of the PTO select lever.
This is because the tractor is equipped with Operator
Presence Control (OPC) system.
"ON" "ENGAGE"
"OFF" "DISENGAGE"
Model [B3350SU]
BPTO Clutch Lever
1. The tractor has a 540 rpm speed position.
2. Shift the lever to "ON" to engage the PTO clutch. Shift
the lever to "OFF" to disengage the PTO clutch.
(1) PTO clutch lever
A To avoid shock loads to the PTO, reduce engine
throttle from high idle to low idle by pushing up on
engine throttle when engaging the PTO, then re-
engage the engine to high idle.
A To avoid damage to PTO clutch and implement, shift
the PTO clutch lever slowly, when engaging the PTO
clutch. Do not keep the PTO clutch lever half way.
Engine speed rpm
Shaft
PTO speed rpm
A Tractor engine will not start if the PTO clutch lever is in
the engaged "ON" position.
A When you stand up from the seat with the PTO clutch
lever in the "ON" position, the engine will stop
regardless of the position of the PTO select lever.
This is because the tractor is equipped with Operator
Presence Control (OPC) system.
PTO 43
"ON" "ENGAGE"
"OFF" "DISENGAGE"
B3350SU
2398
6-spline
540