Dispensing Tea Water - Bosch TCC78K750 Instruction Manual

Preparing milk froth
and warm milk
Risk of burns
The milk frother (12) gets very
hot. After use, allow to cool
down first before touching.
For optimal milk froth quality, use
cold milk with a fat content of at
least 1.5 % if possible.
1. Take the milk tube and connect it to the
milk frother (see "Preparation using milk").
2. Place a cup or glass under the outlet of
the milk frother (12).
3. Select the required
milk
setting by turning the rotary knob
(5):
(
Milk froth
o
start/stop (10); milk froth or
4. Press
warm milk runs out of the milk frother
outlet (takes about 40 or 60 seconds
respectively).
o
start/stop (10) again to cut the
Press
process short.
The appliance may make a
whistling noise when warm milk is
being prepared. This is caused by
the milk frother (12) for technical
reasons.
Dried milk residue is diffi cult to
remove, so clean the milk frother
immediately after use
(see "Cleaning the milk system").
Bosch
Milk froth Warm
or
M

Dispensing tea water

very hot. After use, allow to cool down
first before touching.
The appliance can also be used to prepare
tea.
1. Place a cup or glass under the coffee
outlet.
2. Select
(5):
(
)
3. Press
selection. Set the required temperature
with the rotary knob
(
4. Press
out of the milk frother outlet for about 40
seconds.
o
Press
process short.
Tip: Warm up cups before use, especially
small, thick espresso cups, with the hot
water.
Risk of burns
The milk frother (12), from
which the tea water flows, gets
Tea water
with the rotary knob
Tea water
a
L
p
(4) to switch to the temperature
(5):
Tea water
c
L
o
start/stop (10); hot water runs
start/stop (10) again to cut the
English | 9
)
}
)
}
TCC78K750 | 01/2009