Adjusting The Grinding Unit - Bosch TCC78K750 Instruction Manual

A time between 5 minutes and 8 hours can
be set. The default time is one hour, but
this can be shortened to save energy.
Illumination
– : Press the arrow button
The lighting can be set to
after 5min.
(factory setting).
Tone
– : Press the arrow button
audible signal you hear when a button is
pressed can be switched
turning the rotary knob
Contrast
– : Press the arrow button
display contrast can be set from –20 to
+20 with the rotary knob
setting is 0.
Water filter : Each time a new water fi lter is
–
inserted in the water tank (14), it must be
rinsed:
Place the water fi lter in the water tank
1.
(14) and fi ll the tank with water up to
the "max" mark.
Start with O
2. Press the arrow button
[
o
and press
3. Place a container with a capacity of 0.5
litres under the milk frother (12).
o
start/stop (10). Water will
4. Press
now run fi rst through the fi lter to rinse it
and then into the container.
Empty the container. The appliance is
ready to use once more.
Rinsing the fi lter simultaneously activates
the setting for the
The fi lter is no longer effective when the
Change filter
display appears, or at the
latest after two months. It needs to be
replaced for reasons of hygiene and so
that there is no build-up of limescale (this
could damage the appliance). Replace-
ment fi lters can be obtained from retailers
or customer service (see "Accessories").
After every fi lter change the fi lter must fi rst
be rinsed. Proceed as described at the
beginning of this section.
Bosch
Off On
, or
p
. The
OFF ON
or
.
p
(5). The default
p
]
start/stop (10).
Change filter
display.
If no new fi lter is used, turn the water fi lter
setting to
p
.
Off
by
. The
Factory settings
–
own settings and reset the factory settings.
To activate the factory settings, press
o
start/stop (10).
1. Switch the appliance off fully at the
power switch O/I (2).
2. Press
hold them down, and switch the
appliance on again at the power switch
O/I (2).
The factory settings are reactivated.

Adjusting the grinding unit

The rotary selector (18) on the top of the ap-
pliance adjusts the degree of grinding from
coarse to fi ne as required.
Off
.
You can fi nd detailed information
about the water fi lter in the enc-
losed fi lter instructions.
If the appliance has not been used
for a prolonged period (e.g. during
your vacation) the fi lter should
be rinsed before the appliance
is used again. To do this, simply
dispense a cup of hot water.
: You can cancel your
The appliance can also be reset to
the factory settings as follows:
z p
and (4) at the same time,
18
English | 41
TCC78K750 | 01/2009