Dual Fingerprint Mode - Samsung SSA-S3010 User Manual

reader mode setup

DUAL FINGERPRINT MODE

In Dual Fingerprint mode, you can register two fi ngerprints for one user ID.
If one of your fi ngers is damaged with Dual Fingerprint mode set to USE, you can use the other fi nger registered for the
authentication.
1. Press the SETUP MENU button.
F10
4
2. Use the buttons
press .
ENT
4
3. Use the buttons
•
USE : If set, you can use the Dual Fingerprint mode.
NOT USE : If set, Dual Fingerprint mode is disabled.
4. When done, press ENT

M
For registering fi ngerprints, see the following table.
DUAL FINGER
NOT USE
USE

J
Make sure not to mix Dual Finger enable/disable confi gurations for multiple units.
Otherwise, it may degrade the recognition performance or cause data communication errors.

If you switch the Dual Finger setup from disabled to enabled, all systems should have the consistent setups and
registered fi ngerprints must be registered again. Switching to disabled requires the same.

Before registering fi ngerprints and transfer data, make sure to setup all systems to have consistent setting at the
beginning.
32_
reader mode setup
6
and to move to the DUAL F/P MODE item and
6
and to select the use of Dual Fingerprint mode.
to save your settings.
Template/Fingerprint Count
2 fi ngerprint templates for one fi nger
1 fi ngerprint template for each of 2 different fi ngers
1. DUAL F/P MODE
NOT USE
1. DUAL F/P MODE
NOT USE
1. DUAL F/P MODE
USE
Success Recommended
Ratio Authentication Mode
High Identifi cation mode
Low Verifi cation mode