Assembly Of The Meat Grinder; Assembly Of The Sausage Attachment; Mounting Of The "Kebbe" Attachment; Assembly Of The Cookie Attachment - Proficook PC-FW 1003 Instruction Manual

4. Push the spiral (7) into the horizontal section of
the spiral housing until the axle locks in place.
See also the sections on assembling the meat
grinder, the "Kebbe" attachment, the sausage at-
tachment or the biscuit attachment.

Assembly of the meat grinder

• Please also observe our illustrations under "A"
(Page 74).
• Please follow points 1 to 4 as described under
"Preparation ".
5. Insert the knife with the sharpened edge out-
wards onto the shaft of the scroll.
6. Select a sieve (9).

NOTE:
The guide mechanisms on the sieve fit into the
recesses of the spiral housing.
7. Rotate the catch clockwise.
8. Put the pieces of meat on to the filling tray (1)
and into the filler neck.
See below "Electrical connection".

Assembly of the sausage attachment

• Please also observe our illustrations under "B"
(Page 74).
• First proceed as described under "Preparation"
and "Assembly of the Meat Grinder", points 1 to
6.
7. Position the sausage attachment on the scroll
housing.
8. Rotate the catch clockwise.
9. Fill the sausage paste on to the filling tray and
into the filler neck.
See below "Electrical connection/Application
instructions".

Mounting of the "Kebbe" attachment


NOTE:
Tubes of meat or dough paste can be made with
the "Kebbe" attachment.
• Please also observe our illustrations under "C"
(Page 74).
• Please follow points 1 to 4 as described under
"Preparation".
5. Position the 2-piece Kebbe attachment on the
shaft of the scroll.

NOTE:
The guides on attachment are located in the
recesses on the scroll housing.
6. Rotate the catch clockwise.
7. Place your meat or dough paste on the filling
tray and into the filler neck.
See below "Electrical connection".

Assembly of the cookie attachment


NOTE:
You can shape different forms with this attach-
ment after preparing a cookie dough. This is
particularly suitable for so-called "Spritzgebäck"
(cookies).
• Please also observe our illustrations under "D"
(Page 74).
• Please follow points 1 to 4 as described under
"Preparation".
5. First, insert the disc onto the extension of the
scroll shaft.

NOTE:
The guides are located in the recesses on the
scroll housing.
6. Then mount the shaping disc.
7. Rotate the catch clockwise.
8. Push the rail (14) through the slits of the shaping
disc.
See below "Electrical connection/Application
instructions".

Electrical connection

• Ensure that the function switch is set to " "
(Off).
• Connect the appliance to a correctly installed
and earthed socket 220-240 V AC, 50 Hz.
37