Baumatic BWR1005 Instruction Manual page 35

o When you are facing the rear of the appliance, you will see two
water inlet valves next to each other. The cold water inlet valve
is on the left hand side and the hot water inlet valve is on the
right hand side.
Place the water inlet hose on the water inlet valve at the rear of the
washing machine.
Connect and fully tighten the inlet hoses to the threaded inlet valve
that is located at the rear of the washing machine. On the end of
the water inlet hoses there are connectors that have a nut on it,
you should use these to secure the hoses.
Connect the other end of the inlet hoses to your mains
water supply
o IMPORTANT: If you are using both inlet hoses, then
you must ensure that you connect the inlet hoses to
the correct taps. The cold water inlet valve must be
connected to your cold water tap. The hot water inlet
valve must be connected to your hot water tap.
35