Sliding rack kit assembly
GB
Left
Right guide
guide rail
rail
B
C
D
! Do not place the sliding racks in position 5.
Troubleshooting
Problem
The "Clock button" and the
digits on the display flash.
A programmed cooking mode
does not start.
Only the high luminosity
"Clock button" is lit.
An automatic mode has been
selected. "Hot" appears on the
display and cooking does not
start.
Fan-assisted cooking has been
selected and the food looks burnt.
32
To assemble the sliding
racks:
1. Remove the two frames,
lifting them away from the
A
spacers A (see figure).
2. Choose which shelf to use
with the sliding rack. Paying
attention to the direction in
which the sliding rack is to
be extracted, position joint B
and then joint C on the
frame.
3. Secure the two frames
with the guide rails using the
holes provided on the oven
walls (see diagram). The
holes for the left frame are
situated at the top, while the
holes for the right frame are
at the bottom.
4. Finally, fit the frames on
the spacers A.
Possible cause
The appliance has just been
connected to the electricity mains
or there has been a blackout.
There has been a blackout.
The appliance is in standby mode Press any button to exit
The temperature inside the oven
is higher than the suggested
value for the selected mode.
Positions 1 and 5: the direct
heat could cause
temperature-sensitive
foods to burn.
Solution
Set the clock.
Reprogram the cooking mode.
standby mode.
Wait for the oven to cool down.
We recommend switching
dripping pan positions halfway
through cooking.