909 SSP Instruction Manual page 9

3. Hold the knife handle and
slide the handle end of the
knife edge down the angled
face until it touches the
grinding wheel and draw the
knife towards you. Do not
apply too much pressure.
4. Insert the knife into the other
side of the guide and repeat 3.
5. Repeat sharpening each side
until a clean sharp edge
is achieved.
6. Switch the power unit OFF,
before removing the module.
Ensure the grinding wheel
has stopped.
Sharpening scissors
1. Slide the knife and scissor module (8) on to the power
unit, ensure it clips secure into place.
2. Switch the power unit ON, wait until the grinding wheel
is at full speed.
3. Open the scissors to be sharpened fully.
4. Keeping the pivot of the
scissors to the right hand side,
offer the blade to the face of
the grinding wheel resting the
blade on the angled rib.
5. Draw the blade across the
face of the grinding wheel from
pivot to tip. Use a slight but
steady pressure.
6. Turn the scissors over to sharpen the second blade,
keeping the pivot to the right hand side. Sharpen from
pivot to tip again.
7. Repeat 5 and 6 until a clean sharp edge is achieved.
8. Switch the power unit OFF, wait for grinding wheel to
stop before removing the module.
Sharpening high speed drill bits
Note. Sharpens HSS drill bits from 3mm – 10mm.
1. Slide the high speed drill sharpening module (6) on the
power unit until it clips securely into place.
2. Remove the clamp (7) from the module and insert the drill
bit to be sharpened, tighten the clamp lightly so the drill
bit can still move freely.
3. Place the clamp containing
the drill bit into the depth
setting slot, using the grooves
to locate correctly.
4. Move the drill bit forward so
that it lays in the "V" guide and
touches the metal end stop.
5. Tighten the clamp so the drill
bit is secure.
6. Remove the clamp and drill bit from the setting position
and locate onto the sharpening position ribs, and push
down firmly.
7. Switch the power unit ON.
9