Aastra 6730i Installation Manual page 12

Install on the Wall
The 6730i IP Phone IP phone has two pre-drilled wall mounting holes on the back of the phone.
1. Using the provided wall mount drilling template, locate and mark the position for the mounting screws on the wall.
Depending on the wall type, you may need to use wall anchors. Both the screws and wall anchors are included with
your phone.
2. Place the wall mount holes on the phone over the screw heads on the wall and pull down to lock the phone in.
3. In the handset cradle, there is a small clip that sits flush with the cradle surface. Using a small flathead screwdriver,
pull the clip up and remove it from the phone.
4. With the arms on the clip facing you and the flat side of the clip towards the phone, turn the clip 180 degrees and
reinsert it back into the clip cavity in the phone's cradle.
41-001277-06 Rev 00 – 07.2011
Wall Mount Holes
Installation and Setup
9