OBJ_BUCH-1436-002.book Page 12 Thursday, May 22, 2014 11:35 AM
12 | English
Do not operate without tubes in
place.
Failure to keep long hair away from
the air inlet could result in personal
injury.
Thoroughly inspect the area where
the machine is to be used and re-
move all wires and other foreign ob-
jects.
Check cable for damage before
starting work and replace if neces-
sary. Keep cable away from heat, oil
and sharp edges.
Always direct the cable to the rear
away from the appliance.
Use the machine only in the correct
orientation for its configuration.
This machine is not designed for use
inverted during vacuum mode.
Never operate the leaf blower/gar-
den vacuum with defective guards
or shields, or without safety devic-
es, for example collection bag in
place.
Always ensure all handles and
guards supplied are fitted when us-
ing the leaf blower/garden vacuum.
Never attempt to use an incomplete
leaf blower/garden vacuum or one
with an unauthorised modification.
While operating the leaf blower/gar-
den vacuum always be sure of a safe
and secure operating position at all
times.
Always be aware of your surround-
ings and stay alert for possible haz-
ards that you may not hear whilst
operating the leaf blower/garden
vacuum.
F 016 L81 128 | (22.5.14)
Do not over reach and keep your bal-
ance at all times.
Always be sure of your footing on
slopes.
Walk, never run.
Keep all cooling air inlets clear of de-
bris.
Never blow debris in the direction of
bystanders.
Do not carry the machine by the ca-
ble.
The wearing of a face mask is recom-
mended.
Wear safety goggles.
Do not modify this product. Unau-
thorized modifications may impair
the safety of your product and may
result in increased noise and vibra-
tion.
Remove the plug from the socket:
– whenever you leave the machine.
– before checking, clearing a blockage
or working on the leaf blower/garden
vacuum.
– after striking a foreign object, inspect
the leaf blower/garden vacuum for
damage and make repairs as neces-
sary.
– if the leaf blower/garden vacuum
starts to vibrate abnormally check im-
mediately.
Power supply
The voltage indicated on the rating
plate must correspond to the volt-
age of the power source.
Bosch Power Tools