72 Appendix A Technical specifications
10/100BASE Ethernet interface card
The 10/100BASE Ethernet interface card has a single RJ-45 connector that
provides the signals needed to interface to 10BASE-T and 100BASE-TX Ethernet
equipment.
Figure 27 10/100BASE Ethernet interface card
For information about the cables that you can connect to this interface and the
cable pinouts, see
56/64K CSU/DSU WAN interface card
The 56/64K CSU/DSU WAN interface card has a single RJ-48 connector that
provides the signals needed to interface to network equipment.
the 56/64K CSU/DSU WAN interface card.
Figure 28 56/64K CSU/DSU WAN interface card
The connector on the 56/64K CSU/DSU WAN interface card accommodates an
8-pin RJ-48 modular patch cord. These cables are commonly sold as Category 5,
or Ethernet, cables.
314711-D Rev 00
Figure 27
shows the 10/100BASE Ethernet interface card.
"10/100BASE Ethernet LAN port" on page
56/64K
DDS
Note: Nortel Networks does not supply an interface cable with the
56/64K CSU/DSU WAN interface card.
10972EA
CS260009A
68.
Figure 28
shows