Dual V.35 Wan Interface Card; Figure 36 Dual V.35 Wan Interface Card - Nortel Contivity 1700 Installing Manual

84 Appendix A Technical specifications

Dual V.35 WAN interface card

The dual V.35 WAN interface card has two DB26 connectors that provide the
signals needed to interface to V.35 equipment.
Figure 36

Figure 36 Dual V.35 WAN interface card

You need a DSU/CSU (digital service unit/channel service unit) between the
WAN connection and the gateway. This section describes the connector and cables
used with V.35 WAN synchronous adapters.
If you build your own V.35 DTE cables, observe the following guidelines:
•
•
•
Included in the accessory box are two cables to attach to the V.35 connectors.
These cables enable the WAN adapter to function as DTE (data terminal
equipment).
314711-D Rev 00
shows the dual V.35 WAN interface card.
Note: The dual V.35 WAN interface card is no longer available for
purchase. Version 5.0 is the last release of Contivity software that will
support the dual V.35 WAN interface card.
All connector hoods must be metal.
Braid must enter and make contact inside the metal connector hood.
V.35 conn strain relief must be conductive.
CS260016A