Main Charging Is Not Performed; When The Main Switch Is Turned On; Others - Kyocera Mita KM-1500 Service Manual

2DC
Problem
(13) Broken main charger wire.
Main charging is not
Leaking main charger
performed.
housing.
Poor contact in the high
voltage board connector
terminals.
Defective engine board
(KP-5061).
Defective high voltage
board.
(14) Poor contact in the high
Transfer charging is voltage board connector
not performed. terminals.
Defective engine board
(KP-5061).
Defective high voltage
board.
(15) A piece of paper torn from
A paper jam in the copy paper is caught
paper feed or exit around registration snsor
section is indicated or exit sensor.
when the main
Defective registration sen-
switch is turned on.
sor.
Defective exit sensor.
(16) Poor contact in the con-
The message re- nector terminals of inter-
questing cover to be lock switch.
closed is displayed
Defective interlock switch.
when the front cover
is closed.
(17) Wiring is broken, shorted

Others.

or makes poor contact.
Noise.
1-5-22
Causes
See page 1-5-14.
See page 1-5-14.
Check and remove if any.
Run maintenance item U031 and turn registration sensor on and
off manually. Replace registration sensor if indication of the cor-
responding sensor is not light.
Run maintenance item U031 and turn exit sensor on and off
manually. Replace exit sensor if indication of the corresponding
sensor is not light.
Reinsert the connector. Also check for continuity within the con-
nector cable. If none, remedy or replace the cable.
Check for continuity across switch. If there is no continuity when
the switch is on, replace it.
Check for continuity. If none, repair.
Locate the source of noise and remove.
Check procedures/corrective measures