1
Regulations governing installation
1.1.
Statutory regulations governing installation
Type approvals according to ECE-R 10 (EMC) and ECE-R 122 (Heater) exist
for the Thermo 90 ST WDT heater.
See chapter 14, "Technical data" for the approval number.
The provisions of these Directives are binding within the
territory governed by EU Directive 70/156/EEC and/or EC/
2007/46 (binding for new vehicle types as of 29/04/2009) and
should also be observed in countries in which there are no
special regulations!
Failure to follow the installation instructions and the notes
contained therein will lead to all liability being refused by
Webasto. The same applies if repairs are carried out incorrectly
or with the use of parts other than genuine spare parts. This
will result in the invalidation of the type approval for the heater
and therefore of its homologation/ECE type approval.
1.2.
Additional documentation to be used
These installation instructions do not contain all necessary information and
instructions with regard to the installation of Thermo 90 ST WDT heaters.
In addition, the operating instructions must also be used.
Technical Information
34