Table of Contents
Advertisement
Users Manual
The next step is to connect
CobraNet Source Transmitters to
the CobraNet Receivers in the
RHAON loudspeakers. Click on
one of the Source's green Tx
arrows and then on one of the
loudspeaker's red Rx arrows to
connect the two. The loudspeaker's
Receiver automatically inherits the
bundle settings of the Source
Transmitter. Keep repeating these
steps until all the loudspeakers are
connected.
To correct a mistake or change an
assignment, click on the Receiver
whose assignment you want to
change to select it or right-click on
the Receiver Icon and select
Disable Receiver from the menu
that pops up. Either method will
break the connection and allow you
to make a new one.
Since each CobraNet bundle can
carry 8 channels of digital audio,
you must make channel selections
individually.
Once your Tx and Rx bundle
assignments have been made,
open each loudspeaker's
Properties window by double-click-
ing its icon. If the window does not
open in Connect mode, click on the
Connect tab at the top to display
the window shown at the right.
In the lower-right section of this
window, you make channel assign-
ments by clicking on one of the
white bundle tabs and then on one
of the DSP input tabs to connect
audio channels from the CobraNet
source to the RHAON loudspeak-
er's CobraNet Receivers.
You can also assign Outputs 1 and
2 (selected under Assign CobraNet
Outputs) to the RHAON loudspeak-
er''s CobraNet Transmitters.
20
Advertisement
Table of Contents
