Dust-Away ™ Hard Floor Attachment Use & Care - Shark NV35 Series Owner's Manual

Dust-Away Hard Floor Attachment - Use and Care
™
IMPORTANT: Use only in
Portable Lift-Away mode.
®
Fig. 18
ATTACH PAD
Slip two of the tabs between the suction nozzle and
the Dust-Away base and attach them to the front
™
fasteners on the base. Then pull the other two tabs
tightly around to the back fasteners on the base. For
best results, ensure that the pad is flat against the
bottom surface and secured tightly. (Fig. 18)
CLEAN THE FLOOR
1
Press the extension wand release button and pull
the extension wand up. (Refer to page 9,
Fig. 14-b)
2
Attach Dust-Away hard floor attachment onto the
™
end of the extension wand. (Fig. 19)
3
Press the On/Off switch to the "I" position to
turn the suction motor on and begin cleaning
all hard surfaces.
IMPORTANT: Do not use to clean damp floors or
wet/sticky messes.
CARE FOR PADS
1
Wash the pads separately with warm water
either in the washing machine or by hand
using liquid detergent.
Fig. 19
2
Do not use bleach or fabric softeners as they may
damage or leave a coating that will reduce the
cleaning performance of the pads.
3
Tumble dry low or line dry to extend the life of the
micro-fibre fabric.
REPLACE PADS
1
For best floor cleaning results, we recommend
replacing your micro-fibre pads every 3-4 months
following normal use.
2
You can find and purchase replacement micro-fibre
dusting pads and accessories
at www.sharkninjamanuals.com
TO REPLACE THE MOTORISED FLOOR BRUSH
FOR UPRIGHT CLEANING
1
Press the red release at the bottom of the extension
wand and remove the hard floor attachment.
2
Replace the canister back onto the motorised floor
brush and re-insert the handle with extension wand
back into the top of the vacuum body until you hear
these click into place.
When attaching the motorised floor brush, ensure
that the locking mechanism is fully locked in place to
ensure electrical connection has been made.
CUSTOMER CARE - AU: 1800 890 840
12